Sunday, April 5, 2009

Easter Craft, Day 5:

I've seen these fabric eggs sold in high end department stores. I've always thought they weere very cute, but honestly I can't afford to pay $20+ per egg. So I set out hunting for an easy tutorial on how I could make them myself. And thanks to Retro Mama we've got one!

Fabric Easter Egg Tutorial
10"w x 5"h Quilting cotton, linen or other non-stretchy woven fabric in one or more prints
Fiberfill, Nature-fill or other similar polyester or natural stuffing
Disappearing Ink Pen
Hand sewing needle
Pattern (I recommend printing it on card stock for easy tracing)

Seam allowances are 1/4"

Cut out the pieces. Place pattern piece perpendicular to the fabric selvedge, trace the pattern with disappearing ink (see photo below) and cut four pieces from desired fabric prints. You may cut multiple pieces simultaneously from the same print by folding the fabric over one or more times, cutting up to 4 pieces at once. (Tip: If you're using a scrap and don't know which way the selvedge is, test which direction the fabric is stretchiest. The fabric is stretchier going perpendicular to the selvedge, and less stretchy going parallel with the selvedge; you want the stretch going from top to bottom of the egg, not side to side, so your egg doesn't get too "fat" when you stuff it. Hopefully that makes sense.) Place pieces together for sewing. Always keeping track of which end is "up", place 2 fabric pieces, right sides together, pinning if desired. Do the same with the remaining two pieces. Transfer the two dots from the pattern to the fabric pieces on top. If using two different fabrics, make sure both pairs have one of each print and that the same print is on the top of both sets. Sew a seam along the right side of one set of egg pieces, from top dot to bottom dot, backstitching at the top and bottom. Do the same with the second set of pieces. Put the two halves together. Turn one set of egg pieces right side out, and place inside the other set of egg pieces, so that right sides are together on the inside. Match the seams at the top and bottom and pin. (Note the purple ink marks on the lower righthand side in the photo below that indicate where I will leave a hole for stuffing) Sew the two halves together. Sew around the outside edge of the egg, leaving a 1" hole on one side for turning and stuffing, backstitching at the beginning and end of the seam. Trim the seam allowances, taking care not to snip into the stitches and leaving the seam allowances wide around the open hole. Turn the egg right side out through the hole and it will look something like this Stuff the egg firmly with poly-fill or other stuffing, and close the hole with small slip stitches/ladder stitches. Voila! You have a completed egg.